27 HP Kohler Engine Leaking Oil From the Bottom? (How to Fix)

Quick answer

On a 27 HP Kohler V-twin (Command CH/CV, Courage or 7000 Series), oil leaking from the bottom usually comes from: a loose or double-gasketed oil filter, the drain plug or drain valve, valve cover gaskets (oil runs down and drips from the base), the oil sensor or oil cooler lines, a crankshaft seal, or overfilling and a clogged breather pushing oil out. Clean the engine, run it briefly, and trace the leak to its highest wet point.

Updated November 2026 · Applies to Kohler V-twin lawn tractor and zero-turn engines. Part numbers vary by engine model and spec, so check your engine label.

Step 1: Find the real source

Oil runs downhill and spreads, so the drip point is rarely the leak. Degrease the engine, let it dry, run it for a few minutes on level ground, then look with a flashlight for the highest point where fresh oil appears. Baby powder on a suspect area shows leaks clearly.

Common leak points

Oil filter

Loose filter, an old gasket stuck to the base (a double gasket), or a dented filter. Use the correct filter, such as the genuine 52 050 02-S on many models.

Drain plug or valve

A loose plug, a missing washer, or a drain valve that’s been bumped open.

Valve covers

Hardened gaskets seep, and oil runs down the cylinders. Replace them with the right type, e.g. 7000 Series stamped-cover gaskets or CH-series gaskets.

Oil sensor and lines

A leaking oil-pressure switch or oil-cooler hose fitting.

Crankshaft seal

Oil flung around the PTO end or under the blower housing. This needs the seal replaced.

Overfill or breather

Too much oil, or a clogged breather, pressurizes the crankcase and forces oil out of seals and into the air filter.

Step 2: Fix the easy ones first

  • Check the oil level and drain any excess to the full mark.
  • Remove the filter, clean the base, oil the new gasket lightly and tighten by hand as the filter says.
  • Snug the drain plug and replace its washer, or close the drain valve.
  • Replace hardened valve cover gaskets and torque the screws evenly to spec. Don’t overtighten stamped covers.

Step 3: Check the breather

If oil is in the air filter or seeping from several places, the crankcase breather may be clogged or the rings worn. Clean or replace the breather and check for heavy blow-by.

Step 4: Seals and sensors

A leaking crank seal or oil-pressure switch needs replacing. The PTO-side seal means removing the clutch. Use the parts for your engine model and spec number.

Frequently asked questions

Is it safe to run a Kohler that’s leaking oil?

A slow seep is not an emergency if you keep the oil level up, but oil on a hot muffler is a fire risk. Fix leaks promptly.

Why is oil coming out of my Kohler’s air filter?

Usually overfilling, a clogged breather, mowing steep slopes past the engine’s tilt limit, or worn rings.

Related: Kohler 7000 Series problems · Cleaning a Kohler carburetor · 10W-30 mower oil

Sources and method: Based on Kohler service-manual guidance and standard small-engine leak diagnosis. Part numbers come from current genuine and compatible listings. Confirm them with your engine’s model and spec number.

Update log: November 2026: rewrote the guide. We added a leak-tracing method, a table of common leak points with parts, step-by-step fixes and an FAQ.

Leave a Comment